DFL-100 Release History FW 2.29 New Features : DDNS DDNS Support Peanuthull in China Bugs Fixed: 1. PPPoE ? i. MTU. Now max. MTU is 1492. ? ii. Memory leak when using eMule ? iii. When using PPPoE mode to surf Internet, PPTP/L2TP can't dial up ? iv. WAN mode using PPPoE: remote Management fail. ? v. PPPoE console hang (caused by Connect/Refresh buttons) ? vi. PPPoE idle timeout , session did not clear . ? vii. If our PCs run eMule. After PPPoE idle to time out, device reconnect then console will hang up. 2. NAT Session ? i.The WAN - WAN sessions should show in the System Log, not in the NAT Sessions Table. The NAT sessions Table should record LAN - WAN sessions. ? ii.Session Table limitation: 2049 3. Virtual Server table issue: i. fill up the table ii. delete some rules iii. device reboot iv. the rules that had be deleted are still existed 4. Client uses PAP or CHAP authentication for remote access will cause DFL-100 crash. Notes: Please check your F/W version before do upgrade. If now your F/W version is v1.37, please DO Factory reset before upgrade F/W. fw Changes: 1.New GUI 2.VPN Tunnel No. changed to 25. II.New Features : 1. Web auto save setting 2. DNS Proxy -Basic Setup --> DNS Proxy 3.System - add sys log, e-mail log report, upload/download firewall policies (port filter) only -System Tools --> Admin Settings --> Syslog Settings -System Tools --> Admin Settings --> Email Log Reporting -System Tools --> System Utilities --> Upload/Download Firewall Policies (port filter) only 4.Scheduling -System Tools -> Time Settings 5.Filter -- IP filter, MAC filter, URL filter -Advanced Settings -> Client Filters -> Client URL Filtering 6. VPN-IPSEC Tunnel Mode , Peer Type add : Remote Gateway with Static IP, Dynamic IP, or Remote Client -Advanced Settings ->VPN-IPSEC -> IPSEC Tunnel -> Peer Type 7.Firewall ¡V add port filter policy, Intrusion Detection -Advanced Settings --> Firewall Settings --> Intrusion Detection Settings -Advanced Settings -> Firewall Settings -> Port Filter Policy Please Note that: User must reset configurations if this firmware is used. ========================================================================================================================= DFL-100 Firmware 1.40 (Released: Oct. 15, 2003) fixed the static route issue ======================================================================== DFL-100 Firmware 1.37 (Released: July 3, 2003) First Release. For the function/features, please refer to product data sheet. ========================================================================